Metamask: Metamask wont show up when I am calling approve function using Erc20 token

Here is a step-by-step guide to troubleshooting if Metamask does not appear when calling the approval function with an ERC20 token:

Step 1: Verify Metamask installation and configuration

Make sure you have Metamask correctly installed in your browser. If it is installed but not activated, try activating it by clicking the three dots next to the Ethereum address and selecting «Metamask» > «Activate».

Step 2: Confirm ERC20 token support

Make sure the ERC20 token (e.g. ETH) supports Metamask on your network. You can do this by:

a. Going to the [Metamask]( settings.

b. Reviewing the list of supported tokens and networks.

Step 3: Make sure Metamask is connected

Check that Metamask is connected to your Ethereum account by:

a. Go to [Metamask]( settings.

b. Make sure “Connect Wallet” (or “Wallet” in older versions) is enabled and properly configured.

Step 4: Check contract address

Make sure the contract address you want to call the approval function from matches the address provided by MetaMask when asked for permission:

a. Go to [Metamask]( settings.

b. Click “Wallet” > “Connect Wallet” (or “Connect Wallet” in older versions).

c. Select your Ethereum account and click “Connect”.

d. Go back to the contract address you want to call the approval function from.

Step 5: Verify Metamask functionality

Try enabling full functionality of Metamask by:

a. Go to [Metamask]( settings.

b. Select “Full Wallet” > “Enable Full Wallet”.

c. Click “Save”.

Step 6: Verify token balance and contract permissions

Make sure your ERC20 token balance is enough for the contract function call:

a. Go to [Metamask]( settings.

b. Select the wallet you previously connected (e.g. MetaMask).

c. Go to the “Balances” tab.

d. Make sure your token balance is greater than or equal to the required amount for the contract function call.

Step 7: Verify contract permissions

Make sure Metamask has been granted the necessary permissions for your contract:

a. Go to [Meta-Contract]( or [Etherscan](

b. Select your contract.

c. Click on “Permissions” > “Grant/Revoke Permission”.

d. Make sure Metamask has been granted the necessary permissions for the contract function call.

Step 8: Verify ERC20 token metadata

Metamask: Metamask wont show up when I am calling approve function using Erc20 token

Make sure you have access to the ERC20 token metadata (e.g. “0x…”) in your contract code:

a. Go to [Etherscan]( or [Meta-Contract](

b. Select your contract.

c. Click Token > Metadata.

d. Make sure the metadata is correct and includes the ERC20 token address.

Step 9: Try again

Once you have completed all of these steps, try accessing the approval function from Metamask again:

a. Go to [Metamask]( settings.

b. Select Wallet > Connect Wallet (or Connect Wallet in older versions).

c. Click Save.

d. Go back to your contract address and try accessing the approval function from Metamask.

If none of these steps solve the problem, please provide more details about your setup, including:

  • The specific contract address you want to call the approval function from
  • The Erc20 token address provided by MetaMask when asked for permission
  • Any error messages or logs you may have

Hope this helps! Let me know if you have any other questions.

Role Role Generative

Dejar un comentario

Tu dirección de correo electrónico no será publicada.